:	May 15, 2008

.

Remove the instrument panel driver side reinforcement.

.

:   RHD illustration shown, LHD is similar. Remove the driver side footwell duct.   Remove the 2 Torx screws.

.

:   Some variation in the illustrations may occur, but the essential information is always correct. Remove the temperature blend door actuator.   Disconnect the electrical connector.   Remove the 3 screws.

.

Install the temperature blend door actuator.   Tighten the screws to 1 Nm.   Connect the electrical connector.

.

Install the driver side footwell duct.   Tighten the screws.

.

Install the instrument panel driver side reinforcement.